The inner seal is NOT grooved. That's the dust seal and it's held in place with
the thin metal shield. The inner one is FLAT on all 4 surfaces.
Don't reuse the old ones, get new.
If your pistons have the small cut out on the circumference of the pad contact
surface, the center part of the cut out should be lined up with the bleeder
screw.
Paul A
James Dowling wrote:
> I am sure this will be considered a dumb question but I must take that
> chance. Which way does the inner seal on caliper go? Groove side out or in?
> I know, I shoulda paid attention on removal but they were too trashed to
> tell.
> Jim
> 79 Midget
> Celebrating 2 years of new life today!
>
> Show your love...Share your love
> Be an Organ Donor
> Call 1-800-94DONOR Today!
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|