There are some really junk Aluminum valve covers that got into the
market over the Winter. I ended up with one in a trade so I do not know
who is selling this part. They were priced @ approx $39.00 and were full
of voids in the Aluminum casting and had a single hole drilled to accept
the hold down hardware.
Regards,
Tom Speed
Charlotte, NC
I've stopped 9,704 spam messages. You can too!
Get your free, safe spam protection at
http://www.cloudmark.com/spamnetsig/
-----Original Message-----
From owner-spridgets-mod at autox.team.net
[mailto:owner-spridgets-mod@autox.team.net] On Behalf Of James Dowling
Sent: Saturday, March 22, 2003 2:13 PM
To: spridgets@autox.team.net
Subject: Alloy valve cover advise
I just put on an alloy valve cover but have a concern/question. The
cover
has a flat surface unlike stock and when I snug it up the gasket comes a
squishing out. Am I over tightening? Should I just snug it up? It leaked
and
got my nice clean engine filthy! Also, any input on to silicone or not?
TIA, Jim 79 Midget
Show your love...Share your love
Be an Organ Donor
Call 1-800-94DONOR Today!
/// Send your messages to spridgets@autox.team.net
/// unsubscribe/change address requests to majordomo@autox.team.net or
try /// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|