Tim L. Creger wrote:
> List,
>
> I am to the point where I would like to clean up and restore the
> original 1275 exhaust manifold
> Short of sand blasting, is there any other method of
> restoring this part to a paintable surface?
In my pre glass bead cabinet days, I used a wire wheel on the bench
grinder. That worked pretty good.
I have heard (but can not confirm) that JB-Weld can be used as a bondo
type filler on pock marks and pits on the exhaust manifold.
Smear it on, sand it at just the right time before it gets too hard.
I don't know if JB will hold up to exhaust manifold heat but somebody
once told me it works. I never tried it myself.
--
Frank Clarici
Toms River, NJ
2 Sprites, 2 Midgets
http://www.exit109.com/~spritenut
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|