Hi.
Can't remember where I found them, but I have a couple of small diameter
wire brushes similar to what plumbers use on the inside of copper pipes.
They fit nicely inside the connectors. Spray with brake clean, then use
Copper-shield, anti-seize or similar conductive "stuff" before reassembling.
Good luck
John
Topsfield, MA (currently 5 degrees F)
----- Original Message -----
From "Bill Gilroy" <w.gilroy at verizon.net>
To: <spridgets@autox.team.net>
Sent: Saturday, January 18, 2003 3:58 PM
Subject: Connection cleaning
My question is this, what is the best way to clean the bullet
> connectors at these light. I figure steel wool or emery cloth for the
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|