Thanks for the info. Since I have the 1275, I never bothered to look at the
other engine specs. This kind of sucks though. What should I do? Am I probably
going to have leaks if I leave it as is or should I go ahead and get another
gasket and more bolts and start over?
Thanks,
Eddie
>Yikes! I see in Haynes it does say 20 lbs ft.
>
>Bentley DOES show it. It is 6 lbs.ft.
>
>When using the Bentley factory manual specifications, go first to the
>engine you have, then if not shown, go back to the prior engine, in this
>case 1098cc where it is shown. Bentley only shows what has changed from the
>previous model. I hope that's clear.
> Good luck.
> Peter C
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|