In a message dated 10/19/02 10:52:15 PM Eastern Daylight Time,
androbus@yahoo.com writes:
> did what I thought was a close enough static timing, but can't get it
> to start...will fart out the back a bit, but that's it!
Sounds like you might have the distributor installed 180 degrees out. Move
the piston to TDC and be sure the rotor in the distributor is pointing to the
spark plug wire for that cylinder. If it isn't, you need to pull the
distributor up and turn it around.
--David C.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|