> I am so used to having the plastic floats leak from the overflow, I
> didn't even think about the "too low" fuel level.
> You don't have gross jets do you? Those round ball float valves?
> They may be too long.
> Double up the lid gaskets.
No, I don't have the GroseJets. Haynes says that the gap should be 1/8" to
3/16", but mine were just over 1/4"! I put the floats into the carb tops
that I swiped the older floats from and they were close to the right height,
so I guess the inlet valve assemblies must be too tall as you conjectured.
Dabvid Lieb
Too Many RWAs
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|