Hi list,
I am thinking (only thinking) about cutting some BIG holes in the fenders (a
la race car) to let some air out of the engine bay. Hole size will be 2"
maybe 3" diameter and I think there is some kind of special tool that does
this in sheet metal that not only cuts out the hole but kind of puts a lip on
the hole at the same time. Anyone know what kind of tool I need if I go
ahead with this?
RS
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|