It's my first excursion into tuning the SUs, so bear with me. In prep, I
installed new points, rotor, wires, plugs, condenser, cap, coil (I think the
old one was breaking down)and static timed the engine. So far, so good. My
first step in tuning the carbs was to check the float level. Way off,
according to 3 different manuals. There is no way to adjust. the float is 1
piece conical plastic, including the lever. It does have a second hole where
it looks like a pin should have been. Am I missing pieces from my floats, or
is this model unadjustable. I have pics if that would help. Thanks.
B. Mantz
1971 Midget
1959 Bugeye project
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|