Here you are......
http://www.morbark.com/downloadable_files/pdfs/belttorque.pdf
Doug Ingram
Victoria BC
1958 Sprite (AN5L/636)
1963 Sprite Mk II project (HAN7L/30003)
----- Original Message -----
From "Roger N. Smith" <unltd at aloha.net>
To: <spridgets@autox.team.net>
Sent: Saturday, March 30, 2002 4:39 PM
Subject: Nut and bolt torques
> I'm putting together my 60/65/71 bugeye spridget sub systems and now I
have
> a question as to the torque of common nuts and bolts. All of the nut and
> bolt are being replaced with grade 8 or grade 5 when I can't spend the
time
> to go 60 miles one way to the local Ace Hardware for resupply. Now the
> question. What is the accepted torque for a 5/16",3/8"and 1/2" nut and or
> bolt? In my 40+ years of wrenching (at home for myself) I know I've seen a
> table but I can't for the life of me remember where. As usual any and all
> help will be appreciated.
> Roger Smith
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|