I had the bores on my Bugeye master re-sleeved by White Post for $40.00 per
hole. They wanted to rebuild the entire master cylinder and mentioned that it
was more common for the whole master assembly be sent to them to work on. They
did it anyway and it was quite satisfactory. I did not know about Joe at the
time, but have heard nothing but positive feedback on him.
Mike MacLean-60 Sprite
DLancer7676@cs.com wrote:
> In a message dated 11/27/2001 11:50:56 AM Eastern Standard Time,
> pixelsmith@gerardsgarage.com writes:
>
> > Talk to Joe at:
> >
> > >Sierra Specialty Automotive (Joe)
> > >3494 Chandler Road
> > >Quincy, CA 95971
> > >1 800 4-BRASS-1
> > >1 800 427-2771
> > >530 283-4845 FAX
> >
> > He does great work and is very reasonable too. I've had 6 or 7 done there.
> >
>
> I haven't had this done yet, but I did compare White Post with Joe at
> Sierra--not their work, just their prices and up-front customer contact. I
> was more impressed with Joe and his prices than with White Post. When I get
> mine done, I will go with Joe. Mind you, this says nothing about the quality
> of either's work--I would confidently go with recommendations from either
> Gerard OR Dan. But Joe was less expensive and seemed (gut-feeling) to be
> more approachable on the phone.
>
> --David C.
|