Good morning listers,
This must be an easy question to answer !
Could someone please advise of the correct routing for the wiring loom from
front to rear on my 1971 AH Sprite.
As recevied the wiring has been lashed up and currently runs along the RHS of
the driver's seat and then into the driver's wheelarch via the lowest hole in
the post beside the driver. ( I'm not sure if the term for this is B-Post, it's
the one that has the 3 hoodframe locating bolts at its top,)
Now that I want to add the trim to the post it's clear that if I leave the loom
as it is I'll have to punch a hole in the trim. This can't be right so where
should the loom be located?
Thanks in advance,
Louis Mehr
Manchester, UK
1971 AH Sprite RHD- it now not only starts but has working brakes as well !
|