deep into a project i find myself needing 2 pieces of a spridget.
1. a piece of the cowel where a wiper wheel box passes through the cowel
with the oval hole .
about 1 inch around the hole would fix the problem i have
encountered here.
2. one square foot of bugeye rear deck from the front edge of the rear
deck where the aluminum
rear cockpit trim attaches . along with the brace /stiffner
that is underneath, wich is
welded to the outer skin.
i'm repairing a rear deck wich has been cut for rear braces of a rollbar.
when i got all the putty ground away i found some aluminum siding riveted in
the car and about1/2" of body filler covering the openings. i'm also
repairing the cowel where it was decided that the battery master switch
should be mounted where a wiper wheel box passed through the cowel.
so the hunt is on! who has a rusty hulk or some pre destroyed pieces that
these two bits may be salvaged from?
chuck. cfchrist@earthlink.net
please reply off list as i think this may bore most...? c. :)
now back to sanding...and sanding....and sanding............
|