I've been converting a Minor release arm to use on my wife's car when it
gets the hydraulic clutch. Problem is that I have since found a different
Midget-type arm that is the same length as the one I took off my Sprite but
has the pivot drilling at a different position, thus giving a different
length between the pivot and the point where the pushrod pin sits.
Obviously this also means there is a different length between the pivot and
the centre of the carbon release bearing.
Any ideas which one is correct and what the other one came off of? Neither
has a fully legible part number. One shows 2A ????, the other is nearly
blank.
///
/// (If they are dupes, this trailer may also catch them.)
|