In a message dated 3/22/2001 10:22:36 AM Eastern Standard Time,
macy@bblmail.psycha.upenn.edu writes:
<< I was wondering if anyone had a pattern for a degree wheel they could send
me that I can print out and attach to a piece of aluminum. >>
I have one at the shop where I am going in a few minutes--about 35 miles. I
could put it on the scanner later tonight and send you a picture of it. It
would be pretty late, I think, but you could probably just cut it out, like
you said, and glue it to a piece of aluminum.
--David C.
///
/// (If they are dupes, this trailer may also catch them.)
|