Don't expect much travel in the clutch push rod. If you're draining the MC,
you are probably getting the air out (and probably a face full of fluid as
well).
Anybody know how much travel can be expected? I would think that if your
clutch thrust bearing is near the end of it's life the rod travel be
greater.
Michael Knisely
'71 Midget
----- Original Message -----
From "Eddie Sheffield" <esheffield at prizmail.com>
To: "Spridgets" <spridgets@autox.team.net>
Sent: Wednesday, October 25, 2000 11:27 AM
Subject: Clutch this time, and other woes
> It has NOT been a good morning. Yesterday I put on the new rear wheel
> cylinders and the clutch MC I rebuilt. Today I put on new front brake
bads.
> While putting on the left front I noticed that the A-arm has a *crack*
where
> the lower end of the king pin attaches. *groan* Anyway went ahead and put
on
> the pads and bled the brakes. Bought one of those MityVac kits - the
really
> nice SilverLine with all the goodies. But I can't really tell if it was
> working very well or not. It seemed to be pulling a *lot* more air than I
> would have expected. Finally got my wife out to help and finished it off
the
> old fashioned way. Very little air then, so maybe the vac was pulling air
in
> the line around the fitting or something. Anybody have any experience with
> these things?
>
> But anyway, I went to bleed the clutch, and bled, and bled, and bled. Both
> with the vac and with my wife pumping the pedal. It looked clean when she
> would pump it. But the clutch won't release! Aarrgghh!!! Maybe there is
> still air in the line. When I got the car it had who knows what kind of MC
> on it, sitting at about a 45 degree angle from upright, and was loosely
> mounted. Had the pedal raised WAY up above where it should have been. But
it
> worked, and seemed to work well. I'm wondering if it produced a longer
> stroke at the clutch (I would have thought that might have popped the
piston
> out) and thus sort of compensated for a worn clutch.
>
> So the main question I have now is: How much travel should I see at the
> clutch slave cylinder? Just looking at it, it looks like something between
> 1/2 and 3/4 inch. There's still the possibility that there is air in it
> (sucked the MC dry at one point yesterday) or that the rebuilt I did on
the
> MC was a failure. I really don't want to put a clutch in, as I live in a
> townhouse and can't really pull the engine here.
>
> At least my wife is being an angel through all this. She said its my baby
> and it needs me.
>
> And to top it off, the tranny in our 92 Dodge Caravan started making an
> occasional *clunk* yesterday.
>
> "It never rains, it doesn't even pour, it FLOODS!"
>
> Eddie
> 1971 Midget (behaving badly)
>
>
|