A little brass wire wheel on your drill makes short work of those gaskets.
NAPA stocks new cork ones.
Dave Camp
----- Original Message -----
From "Ryan James Irwin" <rirwin at iusb.edu>
To: <DLancer7676@cs.com>
Cc: <spridgets@autox.team.net>
Sent: Wednesday, October 18, 2000 9:50 AM
Subject: Re: Valve Cover questions
> Ok thanks for the important answer. I spent 15 minutes scraping a rotted
> cork gasket off my valve cover and started wondering if it was supposed to
> be cork or if there was some time/place/situation that it would have been
> reasonable but not correct. As soon as i get a new gasket i can reinstall
> it, the color can wait.
>
> -Ryan Irwin
> '61 Midget
>
> On Wed, 18 Oct 2000 DLancer7676@cs.com wrote:
>
> > In a message dated 10/18/2000 1:31:56 AM Eastern Daylight Time,
> > rirwin@iusb.edu writes:
> >
> > << Also, what
> > material should the valve cover gasket be made of? >>
> >
> > Ryan: Not sure about the '61 valve cover color, but I think green is
right.
> > But I know the gasket should be cork.
> >
> > --David C.
> >
>
>
|