In a message dated 10/04/2000 1:20:17 PM Central Daylight Time,
rob@thomasr.greatxscape.net writes:
<< Am I missing something? >>
Yep.
<< How about cutting off the outer end of the wishbone,
getting a new kingpin cast with a longer hole reamed through the bottom end
and then welding on longer 'tubes' to the edges of the wishbone? >>
Huh?
<<Bigger bore fulcrum pins?>>
OK
<< Would there be a market for these?>>
Nope.
<< Would you buy some if they were available? >>
Nope. Ya can't offer cheap enough.
Unless you have a couple of hundred grand to invest in this endeavor AND most
importantly, an Insurance Company "willing" to underwrite the Product
Liability Policy, Rob, just plain don't think it will work. Besides, WHY
"reinvent the Wheel" at MAJOR expense and Cost??
Cheers..........
Ed
PS: Oh yeah, and where does the R & D Engineering cost get added???
|