Feel lucky it's not the 1500. It's a pain to find a 1
13/16 socket at the local store...Thank god I have a
friend that works on big trucks...!
Dan Dwelley
77 Midget
Alexandria, Va.
--- Brad Fornal <toyman@htcomp.net> wrote:
> The 1275 on the floor in the garage has a 1 5/16
> bolt in it. YMMV
>
> curt.onstott@orst.edu wrote:
>
> > I pulled my engine on Saturday. It was still
> running on three cylinders and
> > I took the car on one last drive beforehand. I
> expect it to be laid up
> > until Summer. Needs a full engine rebuild and a
> Datsun tranny transplant.
> > What size of socket do I need to get the
> Crankshaft pulley bolt off of my
> > 1275? I'd rather use my impact wrench than a
> hammer and chisel :)
> >
> > Curt Onstott - Crop and Soil Science Computing
> Admin
> > Oregon State University. - (541) 737-5875 -
> Office: CrpS 153b
> > http://www.css.orst.edu/curt
> > No, life IS a contest. Perhaps it doesn't FEEL
> like a contest to YOU
> > because I WON so long ago.
> -Voorhis
> > '70 MG Midget '75 Jaguar XJ6 '95
> Specialized RockHopper
>
>
>
>
Do You Yahoo!?
|