I just went through this exercise myself. The bolt is 1 5/16ths". The largest
half inch drive socket I could find is 1 1/4". Argh. The guy at my local
hardware store "rented" me a 3/4" drive socket and 3/4" to 1/2" adapter for $2.
Rick
curt.onstott@orst.edu wrote:
> I pulled my engine on Saturday. It was still running on three cylinders and
> I took the car on one last drive beforehand. I expect it to be laid up
> until Summer. Needs a full engine rebuild and a Datsun tranny transplant.
> What size of socket do I need to get the Crankshaft pulley bolt off of my
> 1275? I'd rather use my impact wrench than a hammer and chisel :)
>
> Curt Onstott - Crop and Soil Science Computing Admin
> Oregon State University. - (541) 737-5875 - Office: CrpS 153b
> http://www.css.orst.edu/curt
> No, life IS a contest. Perhaps it doesn't FEEL like a contest to YOU
> because I WON so long ago. -Voorhis
> '70 MG Midget '75 Jaguar XJ6 '95 Specialized RockHopper
|