Thanks Bob,
I like you reply... simple and to the point.
But can I tell if my rear-end is a wire wheel one that someone changed the
hubs to accommodate steel wheels?
Anybody know the distance from backing plate to the other?
TIA
-Drew
-----Original Message-----
From: Bkitterer@aol.com [mailto:Bkitterer@aol.com]
Sent: Wednesday, November 17, 1999 10:58 PM
To: spridgets@autox.team.net
Subject: Re: RE: Solid vs. Wire Wheels
In a message dated 11/17/99 4:56:08 PM, Andrew.Griffith@ReadRite.com writes:
<< Speaking of rear-ends... Does anybody know how to ID the narrower wire
wheel
rear-end for (1/4 elliptical springs)from the standard one? Any suggestions?
>>
Drew,
Just use a tape measure. You can check between the brake backing plate
flanges. If the differential and axles or out measure through the center
for
over all length.
Bob and Annice
1960 Sprite (Mk IV in disguise)
1966 Sprite Mk III (Trevor) in progress
|