When I replaced the springs on the Sprite, I used a different method than
that suggested so far.
- Install only the front mount of the spring.
- Line up the axle and secure U-bolts while supporting the axle with a jack
and wood or something else to support the spring.
- Remove axle and spring jack and supports. The body is still solidly
supported by stands or whatever.
- Bend a piece of metal into an upside-down U shape wide enough to fit over
the spring. The opening will be the width of the spring. Fit the U over
the back end of the spring and secure the end of the U-shape with a long
bolt or screw.
- Using a long bar, around 5 or 6 feet, slide the bar from the back under
the spring through the U-shape and down to where the axle meets the spring.
- Now have an assistant push the bar down. This brings the spring down and
"rearward" to allow the rear shackle to be installed.
- Install rear shackle and make sure all other fasteners are tight!
Hopefully that's clear!!
Jason.
| Jason Urban - APOGEE LABS 215-699-2060 |
| CA Studio web.p3.net/~jurban |
| '95 Z/28 6spd '65 Austin-Healey Sprite |
| '96 Land Rover Disco |
|