Crash,
you DPO!!
Now you are mixing metric and SAE fasteners on your car. Next you'll weld
the wire wheels to the hubs...
Ulix (X1/9 with recently installed SAE header-to-exhaust bolts)
On Fri, 2 Jul 1999, David Ramsey wrote:
> Frank (and the rest of you "we tight" guys), Did you know the driveshaft
>bolts, nuts, and lock-washers, from the Datsun 210 fit and work fine on your
>spridget! I found this out when replacing my driveshaft and I saw how bad the
>ones on my car were, then I looked in my junkyard tool bag and the Datsun ones
>I put in there looked so much better. You do need to use a 12 mm wrench, but
>the price is right. I've never seen a loose one on a Datsun yet!
> Crash
>
Ulix __/__,__ ___/__|__
..............................................(_o____o_)....<_O_____O_/...
http://students.washington.edu/~ulix/ '67 Sprite '74 X1/9
|