Guy,
the ground clearance issue is more with the center brackets that hold the
bar to the car. They can bottom out, especially on a lowered car.
Ulix
On Mon, 14 Jun 1999, Guy wrote:
> I'm sure that I have seen a square bdy sprite with the anti-roll bar mounted
> "up-side-down" - that is with the short link arms pointing upwards from
> their mounting brackets on the lower wishbone plate.
> This would increase ground clearance
>
> Not tried it, but it would be an easy thing to do.
> Anyone done that ?
>
> Guy
>
> ----- Original Message -----
> From: Ulix Goettsch <ulix@u.washington.edu>
> To: Phil Vanner <pvanner@pclink.com>
> Cc: Spridget List (E-mail) <Spridgets@autox.team.net>
> Sent: 14 June 1999 16:03
> Subject: Re: Sway Bar mountings
> >
> > I think recessing might be a good idea to gain that extra little bit of
> > ground clearance.
> >
> > Ulix __/__,__ ___/__|__
> > ..............................................(_o____o_)....<_O_____O_/...
> > http://students.washington.edu/~ulix/ '67 Sprite '74 X1/9
> >
> >
> >
>
Ulix __/__,__ ___/__|__
..............................................(_o____o_)....<_O_____O_/...
http://students.washington.edu/~ulix/ '67 Sprite '74 X1/9
|