To: | emakris@hol.gr |
---|---|
Subject: | Re: hub nut tool? |
From: | Paul A Asgeirsson <pasgeirsson@juno.com> |
Date: | Sun, 30 May 1999 09:55:29 EDT |
Cc: | spridgets@autox.team.net |
References: | <37505146.160D@hol.gr> |
Reply-to: | Paul A Asgeirsson <pasgeirsson@juno.com> |
Sender: | owner-spridgets@autox.team.net |
Hi Evangelos, 1 7/8" will fit the hub nuts. So will a cold chisel and a hammer! Paul PAsgeirsson@juno.com On Sat, 29 May 1999 23:42:46 +0300 "Evangelos G. Makris" <emakris@hol.gr> writes: >Dear fellow Spridgeteers, > >could you please tell me what size tool (socket) is needed >to play with the hub nuts on the rear axle? >All I know is the LH one is LH-threaded and the RH one is >RH-threaded, am I right? > >Thanks >Evangelos |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Sealing Question, J. Adrian Barnes |
---|---|
Next by Date: | Re: Curling exposed!, Mark Snowdon |
Previous by Thread: | hub nut tool?, Evangelos G. Makris |
Next by Thread: | Sealing Question, J. Adrian Barnes |
Indexes: | [Date] [Thread] [Top] [All Lists] |