Daniel,
When I did mine, I tapped them in with a smallish ball peen after leaving
them in the freezer overnight. I would not use a big hammer on the hub
because you'd have to have it in a vice pretty firmly. I believe the final
seating of the studs is accomplished when you torque done the bolts at
final assembly.
Jeff
At 4:38 PM -0400 5/21/99, Daniel1312@aol.com wrote:
> Hi list,
>
> Anyone have any experience of fitting brand new studs to a new wheel hub (ie
> double bearing conversion at the rear).
>
> If so, how well did the studs go in - big hammer job or what?
>
>
> Daniel1312
Jeffrey H. Boatright, PhD
Senior Editor, Molecular Vision
http://www.molvis.org/molvis
Mailto:jboatri@emory.edu
404-778-4113
|