| To: | mikeg@vicnet.net.au |
|---|---|
| Subject: | Re: Negative Camber and Suspension Geometry |
| From: | Daniel1312@aol.com |
| Date: | Fri, 21 May 1999 16:38:26 EDT |
| Cc: | spridgets@autox.team.net |
| Reply-to: | Daniel1312@aol.com |
| Sender: | owner-spridgets@autox.team.net |
In a message dated 20/5/1999 11:43:07PM, mikeg@vicnet.net.au writes: << I belive they are still available from Tony Bennetto but I'll have to check when he gets back. >> Tony did have some at SpriteRush last year. Is he on the WWW? Daniel1312 |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: AMP vs Volt meter, Daniel1312 |
|---|---|
| Next by Date: | Re: Rear hub bearing help needed, Jeff Boatright |
| Previous by Thread: | Re: Negative Camber and Suspension Geometry, Mike Gigante |
| Next by Thread: | Re: Loctite? (was: Lock tabs vs lock washers), Keith Turk |
| Indexes: | [Date] [Thread] [Top] [All Lists] |