| To: | racer45@bellsouth.net, spridgets@autox.team.net |
|---|---|
| Subject: | Re: Master cylinder question |
| From: | Ronsoave@aol.com |
| Date: | Fri, 9 Apr 1999 09:22:05 EDT |
| Reply-to: | Ronsoave@aol.com |
| Sender: | owner-spridgets@autox.team.net |
In a message dated 99-04-08 23:10:53 EDT, racer45@bellsouth.net writes: > The threads on most of these are rolled not cut and running a > > die over them will introduce a sharp corner at the bottom of the threads Caught my sloppiness again Peter, thanks. I should have suggested using a brass wire brush instead. |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | RE: Master cylinder question, Haynes, Mark |
|---|---|
| Next by Date: | Re: Midget no start, Curtis Carlson |
| Previous by Thread: | RE: Master cylinder question, Haynes, Mark |
| Next by Thread: | Vintage race at Virginia Beach VA, CONAN |
| Indexes: | [Date] [Thread] [Top] [All Lists] |