| To: | Metallian6@aol.com, spridgets@autox.team.net |
|---|---|
| Subject: | Re: Checking bearing specs |
| From: | Lancer7676@aol.com |
| Date: | Thu, 8 Apr 1999 20:26:45 EDT |
| Reply-to: | Lancer7676@aol.com |
| Sender: | owner-spridgets@autox.team.net |
In a message dated 4/8/99 4:57:48 PM EST, Metallian6@aol.com writes: << I don't have any plastie gage on hand. >> James: About any good auto supply will have plasti guage--and it is very cheap--I think I paid under a buck. And it still is probably the best way to check the tolerances as far as I know. --David |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Checking bearing specs, JustBrits |
|---|---|
| Next by Date: | new subscriber, Travis G Elliott |
| Previous by Thread: | Re: Checking bearing specs, JustBrits |
| Next by Thread: | Re: Checking bearing specs, Ronsoave |
| Indexes: | [Date] [Thread] [Top] [All Lists] |