To: | CMLove <cmlove@hiwaay.net> |
---|---|
Subject: | Re: Distributor Rebuild... |
From: | Frank Clarici <spritenut@Exit109.com> |
Date: | Thu, 31 Dec 1998 10:59:28 -0500 |
Cc: | "spridgets@autox.team.net" <spridgets@Autox.Team.Net> |
Organization: | Positive Earth Drivers Club |
References: | <368B04B9.F8C7A409@hiwaay.net> |
Reply-to: | Frank Clarici <spritenut@Exit109.com> |
Sender: | owner-spridgets@Autox.Team.Net |
CMLove wrote: Now I am staring at the plate > that is at the bottom of the housing which was below the weights. It > will not move or come out. Remove the screw under the rotor, drift out the roll pin on the dizzy gear drive on the bottom of the shaft, now everything will come apart. Be carfull with the weight springs, do not stretch them or mix them up. Mark which spring goes on which side. Also mark which way the gear drive goes on, it looks even but it offset ever so slightly, it can be reinstalled 180 out. File a notch on the drive relative to the rotor notch or something so you can keep everything correct. Good luck -- Frank Clarici Toms River, NJ Lots of LBCs http://www.exit109.com/~spritenut |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | RE: Datsun 5-speed conversion, Jackson Zimmermann |
---|---|
Next by Date: | Happy New Year, Biff Jones |
Previous by Thread: | Distributor Rebuild..., CMLove |
Next by Thread: | Originality, Fiats, etc...follow up, Christopher Palmer |
Indexes: | [Date] [Thread] [Top] [All Lists] |