I'm almost ready to put the wheels back on but the drivers side caliper
binds the disc outer face slightly when I tighten the bolts.(no pads yet)
It (the disc) is seated correctly
and the hub is on right (cotter pin hole lined up with axle nut) so I don't
know what the problem is.
I need another 1/32" clearance. Should I try another disc (I bought 4 @
$7.99 from SICP) or
would it be safe to grind a bit off the calliper where it mates with the
swivel axle (it has little nubs
that stick up) ?
Thanks everyone !
Dave
'67 Midget
|