Re: Access to Slave Cylinder on datsun Gearbox

[Ulix Goettsch <ulix@u.washington.edu>]

With the tools at my disposal, I can't!
If you happen to have the right wrench with the right offset, I think you
could.
Ulix


On Wed, 4 Feb 1998 chuckc@ibm.net wrote:

> 
> Hey all you 5-Speeders,
> 
> After you install the Datsun 5-speed in the
> chassis, suppose you want to remove the clutch
> slave cylinder (perhaps you want to pull the
> engine/gearbox again, but do not want to have
> to re-bleed the system). Can you get at the
> top mounting bolt?  How?
> 
> chuck
> 
> 
> 

    Ulix                                                    __/__,__        
.......................................................... (_o____o_)....
                                                           '67 Sprite