| To: | spridgets@Autox.Team.Net |
|---|---|
| Subject: | speed bleeders torque |
| From: | Jeff Boatright <jboatri@emory.edu> |
| Date: | Sun, 11 Jan 1998 13:35:11 -0500 |
| Reply-to: | Jeff Boatright <jboatri@emory.edu> |
| Sender: | owner-spridgets@Autox.Team.Net |
I just got my speed bleeders in the mail. The instructions specify torquing them at a value in inch-pounds. My torque wrench is calibrated in foot-pounds. Is the conversion simply a matter of dividing by 12? TIA, Jeff ______________________________________________ Jeff Boatright __o_\__ '65 A-H Sprite http://userwww.service.emory.edu/~jboatri/sprite/sprite.html |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Homebrew Eezibleed (long), Chuck Ciaffone |
|---|---|
| Next by Date: | Re: Homebrew Eezibleed (long), Lancer7676 |
| Previous by Thread: | Homebrew Eezibleed (long), Patton Dickson |
| Next by Thread: | Re: speed bleeders torque, Ulix Goettsch |
| Indexes: | [Date] [Thread] [Top] [All Lists] |