I have been playing with a set of HS2's for my 1275. One of Vizard's
suggestions to increase flow is to make the throttle shaft narrower
and file off the screws that protrude into the opening. I am aware
that I don't want them coming loose and being sucked into the engine.
The screws are between a 4-40 and a 6-32. Does anybody know what size
they really are? I thought I might put new brass screws in the
narrowed shaft and then solder them in so they won't come loose. Any
better ideas like lock tight or good old J B Weld?
Thanks, It's to cold here for a drive so I thought I would just take
the car apart.
Mark
70 Midget
Nashville
|