spitfires
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

[Spits] Alloy Sway Bar Bracket

from [Daniel Parrott] [Permanent Link][Original]
To: "'Spitfire list'" <spitfires@autox.team.net>, "'Joe Curry'"
Subject: [Spits] Alloy Sway Bar Bracket
From: "Daniel Parrott" <parrotthead01@comcast.net>
Date: Tue, 22 Dec 2009 16:47:14 -0500 
Does any manufacture a nice-looking allow sway bar bracket for a 7/8 in
diameter sway bar, poly bushings (1.25 inches high, 1.3 inches wide and 1
inch deep)?  The standard thin metal bracket doesn't fit.

 

TIA.

 

Dan Parrott

Savannah, Ga

1980 Triumph Spitfire "PJ"

1972/1978 Spit Six Project car "Joseph"
_______________________________________________

Support Team.Net  http://www.team.net/donate.html


Spitfires@autox.team.net
http://autox.team.net/mailman/listinfo/spitfires

http://www.team.net/archive
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
  • [Spits] Alloy Sway Bar Bracket, Daniel Parrott <=
Previous by Date:  Re: [Spits] Differential Installation, Bob Krivnko
Next by Date:  [Spits] Rear Wheel Stud Removal, Daniel Parrott
Previous by Thread:  [Spits] Differential Installation, Matthew Milkevitch
Next by Thread:  [Spits] Rear Wheel Stud Removal, Daniel Parrott
Indexes:  [Date] [Thread] [Top] [All Lists]