At 08:04 PM 11/9/2008, Nick Moseley wrote:
>I've tried two coils, and get the same response:
>
>which is one spark when I first turn the key to Start, then no more sparks.
>
>Any suggestions?
Bad points, or bad condenser. Put a plug wire directly to the coil,
and ground the plug. With the motor turned so the points are closed,
use a small screwdriver to open the points. You should get a spark...
If not, make sure the condenser is not shorted - and make sure the
wires from Dist. to coil aren't broken or shorted somewhere.
Also check the wire that grounds the points plate to the distributor...
Jeff Scarbrough 75 TR6 x 1, 76 1500 x 2, 78 1500 x 1, 80 1500 x 0.5
http://www.fishplate.org/vehicles/
Athens, Georgia #354
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Spitfires@autox.team.net
http://autox.team.net/mailman/listinfo/spitfires
http://www.team.net/archive
|