I'm trying to start my project engine, but I have no spark at the plugs.
I have full voltage at battery. With ignition key turned to run position,
there are 12 volts at the coil.
I've tried two coils, and get the same response:
which is one spark when I first turn the key to Start, then no more sparks.
Any suggestions?
I'm at the point where I might try an electronic ignition dizzy, because
this points version has got me beat.
Other pertinent info is that this is a 76 1500, newly rebuilt, and this is
the first start.
Would this be the symptom if I had the timing gear out by 180 degrees? Might
it be a bad condenser?
Should I try rotating the plug wires on the dizzy? (ie. Move #1 to where #3
was located, and 3 to where 4 was, etc)
Many Thanks
Nick Moseley, NASS #278,
76-81 Spits, GT 6, Metro Vancouver B.C.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Spitfires@autox.team.net
http://autox.team.net/mailman/listinfo/spitfires
http://www.team.net/archive
|