on the bonnet I used an all weather single quick connect from summit
I did
solder the pins
Douglas A. Hansen
www.1147cc.com
----- Original Message
----
From: "mark.jones@exxonmobil.com" <mark.jones@exxonmobil.com>
To:
spitfires@autox.team.net; Mackmi@usa.redcross.org
Sent: Friday, August 29,
2008 1:38:14 PM
Subject: Re: [Spits] cleaning electrical bullet connectors
That would make it rather hard to separate the bonnet from the car without
cutting wires.
Mark
73 MGBGT
76 TR7
80 Spitfire
From:
<Mackmi@usa.redcross.org>
Subject: Re: [Spits] cleaning electrical bullet
connectors
..and if your don't care about originality, just function; then
solder the
wires together, and shrink-tube over the joint.
Mike Mack
79 Spit
70 GT6+
74 VW Thing
_______________________________________________
Support
Team.Net http://www.team.net/donate.html
Spitfires@autox.team.net
http://autox.team.net/mailman/listinfo/spitfires
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Spitfires@autox.team.net
http://autox.team.net/mailman/listinfo/spitfires
http://www.team.net/archive
|