Is the whole care bare metal? If yes, bang out any dents and then shoot
it with an epoxy primer or have someone do it for you. If it is just
bare spots and you are going to do more work anyway then spray on any
lacquer spray paint in a thin coat. You or the body shop will likely
sand it back down to apply bondo to bare metal later. It is always good
measure to spray a primer sealer coat just moments before the color
coats to seal everything below so it wont bleed through, including
rattle can primer.
Rob
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
This e-mail message from State Compensation Insurance Fund and all attachments
transmitted with it may be privileged or confidential and protected from
disclosure. If you are not the intended recipient, you are hereby notified
that any dissemination, distribution, copying, or taking any action based on
it is strictly prohibited and may have legal consequences. If you have
received this e-mail in error, please notify the sender by reply e-mail and
destroy the original message and all copies.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
_______________________________________________
Spitfires mailing list
Spitfires@autox.team.net
http://autox.team.net/mailman/listinfo/spitfires
|