Fill the cavity in the back with Bondo (not just for body work anymore.)
The steps are:
1. Cut off all the posts on the back and sand smooth.
2. Fill the back with Bondo and sand smooth.
3. Hit the Bondo with paint if you are worried about moisture.
4. Apply with double stick trim tape.
Works great on the "MIDGET" letters on an MG.
-g
On 2/15/07, Paul-Ernest Levesque <pelevesque@globetrotter.net> wrote:
>
> Hello
>
> Can someone comment on going that route ((Using 3M double stick trim
> tape))
> for installing the 7 letters TRIUMPH since all letter have cavity in the
> back, and will only stick on the edge back side of the letters, may be it
> is
> o.k. But I would certainly appreciate having other person that has gone
> that
> route.
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|