Naturally you should be using a real gear puller instead of banging, etc.
There is no "secret", as far as I know, and I have managed to take trannys apart
3 or 4 times without any real problem in this area.
I did have a case once where the ball bearing refused to come off the input
shaft
no matter how hard I tried...
Doug Braun
'72 Spit
At 03:25 AM 7/16/2005 +0000, you wrote:
>I'm swapping out my transmission and have run in to a bit of a problem.
>The speedo drive gear is broken on the new tranny so I need to swap it.
>I can figure out how to remove the plastic bit the drives the cable.
>
>Not being able to remove that, I tried reoving the whole tail assembly. I
>was able to pull the driveshaft flange from one, but can remove it from
>the other. Any suggestions on getting either of these pieces swapped?
>
>Andy
>L.
|