To: | <spitfires@autox.team.net> |
---|---|
Subject: | dizzys |
From: | "Larry Vaughan" <lvaughan@pldi.net> |
Date: | Wed, 4 May 2005 19:01:22 -0500 |
I measured the gap under my distributor mounting block and came up with .007" for the gasket. Are gaskets of different thickness available or do I measure various pieces of paper and cut my own. I have to drill a hole in the shaft of my Mallory dual point distributor, for the drive dog rivet. Should it be in the same location as the Delco, in relation to the rotor, or drilled so the Mallory clamps and condensor are in the best position? Larry |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Differential rebuilding article, Barry Schwartz |
---|---|
Next by Date: | Re: Differential rebuilding article, Nolan Penney |
Previous by Thread: | Differential rebuilding article, Barry Schwartz |
Next by Thread: | Diff Question, Andre Rousseau |
Indexes: | [Date] [Thread] [Top] [All Lists] |