OK... had a few peop\le mention it looked like my uprights
were bent. So if I could... would a few of you in a position too...
please look at the illustration and take two measurements for me?
www.teglerizer.com/triumphstuff/blackbeasty/bb_rearspring.html#update2
Also...I'd like to here comments/solutions on bending these back a bit.
Heat? don't trust a re-bend? slow and steady pressure? bend cold?
...nope....no clue how BOTH uprights ended up this way. I'll have
to go out and study the surface area/edges, to see if there are any
'strike' marks that could have bent them from being tossed around
in the warehouse, without the axles in place.
tia
Paul Tegler
ptegler@cablespeed.com
www.teglerizer.com
|