Thanks,
I guess what I'm saying, is the metal door has a
"bump" where the door pull is, and not perfectly flat.
The result will be the very top of panel can't go
against the metal of door above this spot. So I guess
will have to cut a bigger opening to get around this.
Have all door hardware, except clips.....Hummm...44 of
them needed....may use screws....
Donald Stike
--- ptegler@cablespeed.com wrote:
> The Spitfire door and GT6 door inner surfaces
> are identical (per model year at least)
>
> Yes... I've made my own panels for my GT6
> as well as a few of my Spits. I'm not really sure
> what you're talking about with the 'bump' ???
>
> Do you have both 'handle' pieces? There is a metal,
> as well as a plastic 'dish'. There is also a trim
> piece
> that surrounds the opening. If you used your old
> panels
> as a template, there should be no 'fit' problem.
>
> There are a few small holes that clear the screw
> heads that hold the
> door pull on the metal. Is this the 'bump' you're
> referring to?
>
> Paul Tegler
> ptegler@cablespeed.com
> www.teglerizer.com
>
> ----- Original Message -----
> From: "Henry Stike" <stiker2126@yahoo.com>
> To: <spitfires@autox.team.net>
> Sent: Thursday, May 13, 2004 8:24 AM
> Subject: Door Panels
>
>
> > Trying to make new door panels for the 79 spit and
> > discovering there is a buldge that prevents
> cutting
> > out for door pull exactly. If cut out small hole,
> then
> > panel will have a gap at the top?? I guess the
> other
> > option is to cut out bigger hole for door pull and
> > leave enough vinyl to glue to metal of door. Has
> > anyone else done this...I see Tegler has done his
> GT6,
> > but it doesnt look like it has the buldge out like
> a
> > spit 1500.
> >
> > thanks
> > Donald Stike
>
>
__________________________________
Do you Yahoo!?
Yahoo! Movies - Buy advance tickets for 'Shrek 2'
http://movies.yahoo.com/showtimes/movie?mid=1808405861
|