Listerees,
I seem to remember reading about a modification where by the clutch
could be bled from inside the engine compartment...
Basically a male fitting is attached to the clutch slave cylinder bleed
- and then on the end of a pipe attached to that is a female fitting
with a bleed nipple...
Now - I have infront of me a catalogue with lots of Goodridge parts...
female, male - various hose sizes... but what do I need to buy to make
this work? I have no clue for the sizes I need.
3/8 and 7/16 seem to be the common sizes...
Can anyone help?
James
69 Signal Red Spit
|