At 09:43 PM 7/18/2003 -0600, you wrote:
>Mind you, I didn't put the "Seelastic" in the rubber seal before putting it on
>the glass, as recommended in the Haynes manual. But I will put a seal of
>Urethane around the edge, as recommended by several glass installers and
>friends.
Hello,
My windshield seal is getting a bit crumbly and leaky, and
I am contemplating replacing it (the glass itself is OK).
I am wondering:
1: What exactly was the "urethane" you used as a sealant?
2: Are the replacement seals well-made? Any recommended vendor, or they all
the same?
3: Is it necessary to remove the dash to do a good job across the bottom?
Thanks,
Doug Braun
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|