spitfires
[Top] [All Lists]

Re: Calling all electricians...

To: <spitfires@autox.team.net>
Subject: Re: Calling all electricians...
From: Dan Canaan <flinters@picarefy.com>
Date: Thu, 20 Mar 2003 11:41:07 -0800
Does the relay click when you supply 12 vdc and ground from the battery 
with test leads?  Will this cause the horn to blow?


No: Check polarity of relay.  Some are polarized with a small diode inside 
to prevent damage by a collapsing magnetic field when the relay's coil is 
released.  The case should be stamped with the connections.  Try again with 
reversed leads.

Yes: Great!  The relay is good, as is your wiring to the horns.  We just 
need to get the relay to work from the wires attached to the car- they 
always work on the bench but Lucas lives on.   If the relay works with 12 
vdc applied with the test leads, reconnect the horn to the harness and try 
only jumping a wire from the positive battery terminal to the positive 
terminal on the relay.

Hit the horn button.  Does it work?


No: The relay is not receiving the switched ground current from the horn 
button.  That passes from the front of the chassis to the steering rack via 
a small flexible strip on top of the grease nipple of the steering 
box.  The current passes through this column to a sliding joint with 
another flexible strip.  On up to the center of the steering column to the 
switch.   With a test light connected to a good known source of constant 12 
vdc, touch the horn contacts in the steering wheel.  If test light lights 
up with the contacts closed, then you know the ground path from chassis to 
that point is good.  That's the hardest part.  Follow the lead as it exits 
the steering column under the dash and continues to the horn relay 
itself.  Keep testing it at various points to make sure the current flows 
when you hit that horn button all the way to the terminals on the relay.

Yes: You're not getting a constant 12 vdc to the relay.  While you could 
bypass that with your own wiring, it's better to go back from the relay 
through the harness and find out where it is no longer making contact.

Having a couple of 8 foot lengths of test lead works wonders for bypassing 
issues while testing.  It's cheap and very easy to make from wire and 
alligator clips.

-Vegaman Dan
---------------------
This message has been sent by Dan Canaan, aka Flinthoof.  All content is 
copyrighted by this individual for better or for worse, especially if there 
is mint involved.  We thank you for your support.  Please give mint to your 
local Mint Cross Center. 

///  spitfires@autox.team.net mailing list
///  or try  http://www.team.net/cgi-bin/majorcool
///  Archives at http://www.team.net/archive


<Prev in Thread] Current Thread [Next in Thread>