You might check out http://www.metalshapers.org or the yahoo groups
metalshapers, metalshaping and autobodyrepair. Each of them has
something about panelbeating. The best book I've found is "The Key to
Metal Bumping" by Frank T. Sargent. It's rather old, but quite
thorough. IIRC, Eastwood carries it. (certainly others, too.)
HTH
Donald.
> From: "Geoff Heyland" <gheyland@odyssey.on.ca>
> Date: Sat, 1 Mar 2003 09:18:53 -0600
>
> John Zissler's question sparked one of my own - I hear a lot about hammering
> out dents with a hammer and dolly - I've seen dollies, but never seen them in
> action. How are you supposed to use dollies to hammer out dents? Do you put
> them on the inside of the dent and hammer them, or do you put them on the
> outside and hammer from the inside or what? Is there a decent source on the
> web that can educate me on this?
>
> Geoff Heyland
> 65 Mark II
> 67 Mark II
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|