Dave when I did mine (76) the only extras I needed were the copper
bushings on the lever pin. The pin goes on the outside, but on the
inside where the lever pivot goes in the bellhousing, the bushings were
shot. I got ones of the same inside and outside diameters at an
autoparts store. They are in fact the ones for (chevy?) door pins.
Slightly different length, but that was not what mattered. No seals or
gaskets needed as it's a dry area.
Alan
D T Gebhard wrote:
>Spitlisters,
> Good day from frosty northern Indiana. I intend to purchase and replace my
>clutch(1977 1500) with the kit thats on sale with V.B. It includes clutch,
>pressure plate, throw out bearing and an alignment tool. I can do the job but
>I'm wondering if there's any other seals,gaskets,ect. that I need to do while
>I'm *in there*.
> Thanks
> Dave Gebhard
> 1977 1500 FM60984U
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|