Front swaybar mount

["Larry Vaughan" <lvaughan@pldi.net>]

I had to cut my front swaybar u-bolts off and the bushing brackets were
mashed. The frame fixture, where the u-bolt fits, is bent up, in the back,
on both sides.
My first thought was to use my big hammer and knock them level. Then I
thought there should be a better way.
Should I use a big cresent wrench and bend it down cold or heat it up and
bend it down?
Larry

///  spitfires@autox.team.net mailing list
///  or try  http://www.team.net/cgi-bin/majorcool
///  Archives at http://www.team.net/archive